> Chassis 149 ¾" Wheel Base Chrome Moly
> Front Axle Billet Aluminum Spindles (16" tires)
> Steering Box Stiletto Rack & Pinion
> Steering Wheel Billet Butterfly
> Quick Release Billet Aluminum (HRC)
> Pedals Billet Aluminum Adjustable
> Seat One Piece Fiberglass
> Harness M & R Five Point Bolt-In
> Kill Switches Pre-wired through chassis
> Fuel Cell Aluminum (HRC)
> Rear Chassis Chrome Moly
> Motor Plate Billet Aluminum with jack shaft
> Rear Bearings Ultra Free Spinning
> Axle 16" x 1 ¼" Aluminum
> Gear Hub Billet Aluminum
> Brakes Strange Engineering
> Master Cylinder MCP
> Brake Rotor Steel 7"
> Brake Hub Billet Aluminum
> Brake Lines Russell coated SS braided
> Guards Aluminum chain
> Rear Hubs Billet Tribal Art (HRC)
> Rear Rims 8" x 6" polished Alum (HRC)
> Rear Tires M/T 18"/8"-8" (M2)
> Front Rims 16" Pro-Star
> Front Tires 16" x 1.75"
> Powder Coat Black
> Body One piece fiberglass
> Windshield Pro Glass smoked Lexan

This was the last 2007 manufactured at Harden's. Minimal run time on car. Everything in perfect condition.

Car is a roller complete w/NHRA accepted kill switch, MyChron 660 Tach (New in Jan 2008),

E-mail for pics.

5500.00

New lowered price--5K

4750$ new lowered price.

Where does John mark the year on these or does he ? I have 2 hardens but haven't seen it stamped anywhere ?

I was also told at the ECF that they will need helmet bars for next year .

It isn't marked on the car that I have found. However, I have documentation from Harden's supporting my advertisement. I picked the car up in late December 07 from Harden's.

Let me know if your interested.

Depends on the car. We had tech look over our current set-up with a driver seated w/helment. A straight edge was placed to see if any part of the helmet pertruded which it did not. I was already planning to add helmet bars this winter if the car didnt sell just so there wouldn't ever be any gray areas.

I have brand new roll bar padding also.

Where are you located?

DFW Metroplex.

Need to sell 4500.00